Router Simulation Dependable Toolpath Verification Mastercam gives you the confidence to run even the most complex cutter paths on your machines. You can easily check that the motion delivers exactly what with Mastercam’s toolpath verification tools. Watch and measure your part as it is cut from a solid block of material with Mastercam's solid model toolpath verification. The tool and holder are checked and displayed during simulation. Simulate a machine’s motion as it cuts your part with the free Machine Simulation utility. Turn portions of your machine on or off for easier viewing, and zoom in and rotate the part while the operation is in process for closer inspection. Play the program with toolpath backplotting and get an estimate of machining time. Dynamically view all the vital information about tools and operations at any point, and even isolate specific areas to watch more closely. Quickly verify 2D toolpaths with a pixel paint of the full tool diameter to check the finish. Define Your Shop Mastercam’s Machine and Control Definition delivers a new way to make sure that your parts are done right the first time. Define features and characteristics for all the machines in your shop. Mastercam allows you to program only within the chosen machine’s capabilities. Drag preprogrammed toolpaths from one machine to another. Mastercam checks that they will run on the new machine, automatically making adjustments where possible. Mastercam tailors the interface to your selected machine’s capabilities, and will even automatically load the toolbars that make you most efficient.